Do I need a block heater, and how long should I plug it in?
Short answer
If you park outside where it regularly gets down to about 0°F (-18°C) or colder, yes: GM and Ram owner's manuals recommend using a block heater at that temperature, and Ram says it's required below -20°F (-29°C). Plug it in about 3 to 4 hours before you drive (CAA-Quebec, SaskPower); leaving it on all night only wastes electricity, so put it on a timer.
Safety first. Unplug the cord before you start the engine or drive off, and store it away from moving parts (Chevrolet owner's manual). Plug only into a grounded, three-prong outlet: GM warns an ungrounded outlet can cause electric shock, and the wrong extension cord can overheat and start a fire. Don't use a cord that's cracked or damaged. Don't plug in while parked inside a garage or carport (GM Authority; Winnipeg Fire Paramedic Service). Having a block heater installed means working on the cooling system: unless you know what you're doing, have a mechanic do it.
On this page
Step by step
- 1
Check whether your car already has one
Many trucks and cars sold in cold regions have a factory block heater. Look for a three-prong plug tucked behind the grille or bumper (on the 2022 Ram 2500/3500 it's behind the front bumper, through the right hole of the air dam) or coiled under the hood (on the 2012 Chevrolet Traverse it's on the driver side, routed around the washer fluid reservoir). Your owner's manual will have an 'engine block heater' or 'engine coolant heater' section if it's equipped.
- 2
Decide by the temperature where you park
GM and Ram's manuals both put the line at 0°F (-18°C): below that, use it. Ram says it's required below -20°F (-29°C). CAA-Quebec is more cautious: plug in below -5°C (23°F), and it's highly recommended at -15°C (5°F) or colder. Capital One's car site says on a modern car it's usually only needed on nights at 5°F or lower.
- 3
Plug in about 3 to 4 hours before you leave
CAA-Quebec says 3 to 4 hours before driving is enough, with no need to leave it on all night. Chevrolet's manual says at least four hours; Ram's says at least one hour for an adequate warming effect. SaskPower says research shows plugging in for more than four hours is redundant.
- 4
Use a timer
A heavy-duty outdoor timer lets you plug in at night and have the heater switch on a few hours before your commute (Capital One, CAA-Quebec). SaskPower says a block heater timer can save its customers up to $25 a year in electricity.
- 5
Use the right outlet and cord
Plug into a grounded 110-volt, three-prong outlet. If the cord won't reach, Chevrolet's manual says use a heavy-duty three-prong extension cord rated for at least 15 amps, and GM Authority adds it should be weatherproof. Ram's heater draws 6.5 amps at 110 volts, so a light indoor cord isn't up to it.
- 6
Unplug before you drive, by the plug
Winnipeg Fire Paramedic Service says driving over the cord can crack it and raise the risk of an extension cord fire, and pulling by the cord instead of the hard rubber plug end can break it. Store the cord the way it came and put the protective cover back on the plug (Chevrolet manual, Winnipeg Fire).
- 7
Inspect the cord every fall
Check the cord for cracks, cuts and corrosion before each season; GM Authority says inspect it before each use and never use a damaged one. Winnipeg Fire recommends having a mechanic inspect the block heater cord each fall.
Who actually needs one
A block heater (also called an engine coolant heater) is an electric element that warms the engine’s coolant or block while the car is parked, so the engine starts warm instead of cold-soaked. You plug its cord into a household outlet.
| Where you park overnight | Do you need it? |
|---|---|
| Heated garage | No. CAA-Quebec says it isn’t essential; don’t plug in inside an attached or heated garage (Winnipeg Fire). |
| Outside, rarely below 23°F (-5°C) | Probably not. Even CAA-Quebec, the most cautious source here, starts plugging in at -5°C (23°F). |
| Outside, regularly near 5°F (-15°C) | Worth it. CAA-Quebec and CAA Saskatchewan recommend plugging in at about -15°C; Capital One says 5°F or lower. |
| Outside, 0°F (-18°C) or colder | Yes. GM and Ram manuals recommend it at 0°F. |
| Outside, -20°F (-29°C) or colder | Yes. Ram’s manual says it’s required for its heavy-duty trucks. |
These thresholds come from different sources and different engines; your owner’s manual is the final word for your car. Some GM heaters have a thermostat in the cord that won’t switch on above 0°F (-18°C) at all (Chevrolet manual), so plugging in on a mild night may do nothing.
What it does for you
- Easier starts. A warm engine turns over more easily and draws less from the battery (CAA-Quebec). A cold battery also has less power to give (Capital One). If your car struggles on cold mornings, see why a car won’t start in cold weather.
- Oil that flows right away. Capital One says a block heater keeps the oil thinner, so it protects the engine immediately after start-up and can reduce wear over time.
- Less fuel and fewer emissions on warm-up. CAA-Quebec says up to 15 percent less fuel, more on short trips, and lower start-up emissions because the catalytic converter starts working sooner.
- Heat sooner, less idling. A pre-warmed engine gets warm air to the defroster faster, which cuts the urge to idle in the driveway. See how long to warm up your car in winter.
How long to plug it in
| Source | How long |
|---|---|
| CAA-Quebec | 3 to 4 hours before driving; not all night |
| Chevrolet manual (2012 Traverse) | At least 4 hours |
| Ram manual (2022 2500/3500) | At least 1 hour |
| SaskPower | 4 hours; more than 4 is redundant |
| GM Authority | Typically up to 4 hours in very cold conditions |
The overlap is about 3 to 4 hours. If you leave at 7 a.m., set a timer to switch on around 3 a.m.
Where the sources disagree
- The temperature to start plugging in. CAA-Quebec says below -5°C (23°F); CAA Saskatchewan says -15°C (5°F); GM and Ram say 0°F (-18°C). The Canadian clubs are more cautious and focus on fuel and emissions savings as well as starting. This page uses the automakers’ 0°F as the “you need it” line and the CAA numbers as “worth plugging in.”
- Minimum time. Ram says one hour is enough for an adequate warming effect; Chevrolet says at least four. Plan on 3 to 4 hours unless your manual says otherwise.
- How long is too long. SaskPower says past four hours gains nothing; GM’s manual says to ask a local dealer because it depends on conditions. None of the sources say an overnight plug-in damages the engine; the cost is electricity.
Electricity and cost
Ram’s manual says its heater draws 6.5 amps at 110 volts. By our arithmetic that’s roughly 700 watts while it’s on; heaters on other cars vary. SaskPower says a timer can save up to $25 a year in electricity compared with plugging in all night (Canadian dollars; SaskPower’s figure).
If you’d rather not touch the cooling system, an oil pan heater is the simpler (and weaker) alternative: see oil pan heater vs block heater.
To add one to a car that doesn’t have it, Capital One says the part is usually under $100 plus labor, and GM Authority says GM’s factory option is typically about $100. CAA-Quebec quotes about $50 to $200 for the part and $100 to $250 or more for installation in Canadian dollars. Installing one involves the cooling system; CAA-Quebec says a properly installed heater won’t damage the engine when it’s put in to the manufacturer’s recommendations or by a certified mechanic.
Cord safety checklist
- Grounded, three-prong outdoor outlet only (Chevrolet, GM Authority).
- Extension cord: heavy-duty, three-prong, weatherproof, rated for at least 15 amps (Chevrolet, GM Authority).
- Don’t plug in inside a garage or carport (GM Authority, Winnipeg Fire).
- Unplug before starting or driving; pull by the plug, not the cord (Winnipeg Fire, Chevrolet).
- Put the cap back on the plug to keep out dirt and corrosion (Winnipeg Fire, Ram).
- Inspect the cord every fall; never use a damaged one (Winnipeg Fire, GM Authority).
Related winter answers
Common follow-up questions
At what temperature should I plug in my block heater?
GM and Ram owner's manuals say at or below 0°F (-18°C), and Ram says it's required below -20°F (-29°C). CAA-Quebec says plug in below -5°C (23°F), and CAA Saskatchewan says -15°C (5°F). If you're anywhere near those numbers, plugging in costs little and makes starting easier.
How long should a block heater be plugged in?
About 3 to 4 hours before you drive. CAA-Quebec says 3 to 4 hours is enough, Chevrolet's manual says at least four, Ram's says at least one hour, and SaskPower says more than four hours is redundant.
Is it bad to leave a block heater plugged in all night?
It won't usually hurt the engine, but it wastes electricity: after about four hours you aren't gaining anything (SaskPower). CAA-Quebec says there's no need to keep it on all night. A timer gives you the same warm engine for less.
How much electricity does a block heater use?
It depends on the heater. Ram's manual says its heater draws 6.5 amps at 110 volts, which works out to roughly 700 watts while it's on. That's why a timer matters: four hours uses about half as much as eight. SaskPower says a timer can save up to $25 a year.
Does a block heater save gas?
Yes, during warm-up. CAA-Quebec says a plugged-in vehicle can use up to 15 percent less fuel, with bigger savings on short trips under 20 km (about 12 miles), and it cuts start-up emissions because the catalytic converter warms up faster. Chevrolet's manual and GM Authority also say it improves fuel economy during warm-up.
How much does it cost to add a block heater?
Capital One's car site says the part usually costs less than $100, plus labor if a shop installs it, and GM Authority says GM's factory option is typically around $100. CAA-Quebec quotes about $50 to $200 for the part and $100 to $250 or more to install (Canadian prices). Freeze-plug heaters are usually the cheapest but the hardest to install (Capital One).
Should I plug in my block heater in the garage?
Not in an attached or heated garage. Winnipeg Fire Paramedic Service says it can overheat extension cords, and GM Authority says don't plug in while parked in a garage or carport. CAA-Quebec says if you park in a heated garage, you don't need a block heater anyway.
Will a block heater help my battery?
Yes. A warm engine turns over more easily, so the start draws less from the battery (CAA-Quebec), and Capital One notes a cold battery has less power available to begin with. It also keeps the oil thinner so it flows right away, which Capital One says can reduce engine wear over time.
Sources
- 1.CAA-Quebec: Engine block heater in winter: Is it necessary in Quebec? (updated Oct 28, 2025)
- 2.Ram 2500/3500 Owner's Manual (2022): Engine Block Heater
- 3.Chevrolet Traverse Owner Manual (2012): Engine Heater, p. 9-18
- 4.GM Authority: GM Engine Block Heater: Everything You Need to Know (Feb 2026)
- 5.Capital One Auto Navigator: When Should You Get an Engine-Block Heater? (Benjamin Hunting, Feb 7, 2024)
- 6.SaskToday: Block heater timers equal powerful savings (SaskPower and CAA Saskatchewan)
- 7.Global News: SaskPower provides tips to shave costs off power bills during cold snaps (Brady Ratzlaff, Feb 22, 2021)
- 8.City of Winnipeg: Winnipeg Fire Paramedic Service reminds citizens to avoid winter fire hazards (Nov 28, 2014)
General information only, not a diagnosis. Your owner’s manual comes first. How we write these
Related questions
- Oil pan heater vs block heater, which is better?
- Do I need thinner oil in winter? (0W vs 5W vs 10W)
- Do I need a battery blanket or battery heater in winter?
- Why won't my car start in cold weather?
- Should I warm up my car in winter, and for how long?
- Is it bad to let my car sit all winter? How do I keep the battery and tires from going bad?
- Why does my car battery keep dying?
- What should I keep in my car in winter in case I get stranded?