How do I test a car battery with a multimeter? (Voltage chart, cranking and alternator test)
Short answer
Set the multimeter to 20 V DC, touch red to the positive (+) terminal and black to negative (-) with the engine off: about 12.6 volts or more means fully charged, 12.4 V is about 75%, 12.2 V about 50%, and 11.9 V or below is discharged (Battery Tender, NAPA, Interstate Batteries). Then watch the meter while a helper cranks the engine: a good battery stays above 9.6 volts (NAPA, Advance Auto Parts). With the engine running, 13.7 to 14.7 volts means the alternator is charging (NAPA, Optima, Battery Tender).
Safety first. Wear eye protection and gloves, take off rings and watches, and work in a ventilated area with no sparks or flame: batteries give off hydrogen gas (Battery Tender). Don't let a metal tool touch the positive terminal and the car body at the same time. Keep hands, probes and leads clear of the fan and belts when the engine is running. Never crank the engine with the meter connected in series for a drain test: the starter current blows the meter's fuse (Battery Tender). A rotten-egg smell, a swollen or cracked case, or a leaking battery means stop and have it checked (Interstate Batteries).
On this page
Step by step
- 1
Let the surface charge go
A battery that was just driven or charged reads falsely high. Battery Tender says the best reading comes after the car has sat about 12 hours (overnight); if you can't wait, turn the headlights on for 2 minutes with the engine off, then off, and wait 5 to 10 minutes (Battery Tender; Interstate Batteries uses the same 2-minute headlight trick).
- 2
Set the meter and connect it
Set the multimeter to DC volts, 20 V range if it isn't autoranging (Advance Auto Parts, Battery Tender). Turn the ignition and all accessories off. Touch the red probe to the positive (+) terminal and the black probe to the negative (-) terminal. A minus sign on the reading just means the probes are reversed (Advance).
- 3
Read the resting voltage
12.6 V or more = fully charged; 12.4 V = about 75%; 12.2 V = about 50%; 12.0 V = about 25%; 11.9 V or below = discharged (Battery Tender, NAPA). Below 12.4 V, charge the battery before going further (Advance, Battery Tender). AGM batteries rest higher, about 12.8 to 13.0 V when full (Battery Tender).
- 4
Do the cranking test
Only on a battery that read 12.4 V or more. Leave the probes on the terminals and have a helper crank the engine for 5 to 10 seconds, no more than 15 (Battery Tender, Advance). A healthy battery stays above 9.6 V (NAPA, Advance). Battery Tender, at about 70°F: 9.0 to 9.6 V is weak, below 9.0 V on a fully charged battery means replace it.
- 5
Check the alternator with the engine running
Start the engine and measure across the battery terminals again. 13.7 to 14.7 V means the charging system is working (NAPA, Optima, Battery Tender). Battery Tender says to hold about 2,000 rpm with the headlights and blower on: below 13.5 V points to a weak alternator or loose belt, above 15 V to a failing voltage regulator.
- 6
Decide what the numbers mean
Good resting voltage, good cranking voltage and 13.7 to 14.7 V running: the battery and charging system look fine, and a car that still dies overnight may have a parasitic drain (see below). Low resting voltage that comes back after a full charge: the battery was just run down. Won't hold 12.4 V after charging, or drops under 9.6 V cranking: the battery is failing. Interstate Batteries notes a 12.5 V reading alone doesn't prove the battery is good, so if in doubt have it load-tested (Optima recommends a professional load or bench test).
Car battery voltage chart
Engine off, battery rested (ideally overnight). Standard 12-volt flooded lead-acid battery.
| Resting voltage | State of charge | What to do |
|---|---|---|
| 12.6 V or more | about 100% | Healthy; go on to the cranking test |
| 12.4 V | about 75% | OK; top it up with a charger |
| 12.2 V | about 50% | Recharge before testing further |
| 12.0 V | about 25% | Recharge now; sulfation risk |
| 11.9 V or less | discharged | Full recharge, then retest |
Chart rows from Battery Tender; NAPA gives the same 12.4 / 12.2 / 12.0 / 11.9 figures. AGM batteries rest higher when full, about 12.8 to 13.0 V (Battery Tender). For charge times, see how long to charge a car battery.
The three readings that matter
| Test | Good | Problem |
|---|---|---|
| Resting (engine off, rested) | 12.6 V or more | Below 12.4 V: charge it; won’t get back to 12.4 V after charging: failing battery |
| Cranking (helper starts the engine) | Stays above 9.6 V | 9.0 to 9.6 V weak; below 9.0 V on a full battery: replace (Battery Tender) |
| Running (engine on) | 13.7 to 14.7 V | Below 13.5 V: alternator or belt; above 15 V: voltage regulator (Battery Tender) |
If the running voltage is low, also read battery light on while driving: the warning light usually means the charging system, not the battery.
Testing for a parasitic drain
If the battery tests fine but the car is dead after sitting, something may be drawing power with the key off. Battery Tender’s method:
- Close the doors, lock the car and wait 20 to 45 minutes for the modules to sleep.
- Disconnect the negative battery cable.
- Set the meter to 10 A DC, with the red lead in the meter’s amps jack, and connect it in series: one probe on the negative post, one on the cable end.
- Normal is roughly 20 to 50 milliamps (0.02 to 0.05 A). Above 50 mA, pull fuses one at a time; when the reading drops, that circuit has the drain.
- Put the red lead back in the volts jack afterward, and never crank the engine while the meter is in series.
More causes and fixes: why a car battery keeps dying.
Where the sources disagree
- How long to wait before reading. Battery Tender says about 12 hours of rest gives the best reading; Interstate Batteries and Battery Tender both offer a shortcut (headlights on 2 minutes, then off). We give both: rest overnight if you can.
- “Good” running voltage. NAPA, Optima and Battery Tender’s multimeter guide say 13.7 to 14.7 V; Battery Tender’s rest-voltage guide says 13.8 to 14.7 V; Interstate’s video just says above 13 V. Use 13.7 to 14.7 V, and treat a steady reading under 13.5 V as a reason to have the charging system tested.
- The bottom of the chart. Battery Tender’s multimeter guide and NAPA call 11.9 V discharged; Battery Tender’s rest-voltage guide uses 11.8 V or lower. Either way, a battery that low needs a full charge and a retest.
- What counts as a weak crank. NAPA and Advance use one line: below 9.6 V means a weak battery. Battery Tender splits it: 9.0 to 9.6 V weak, below 9.0 V on a fully charged battery means replace.
- Parasitic draw limit. Battery Tender’s two guides say 25 to 50 mA and 20 to 50 mA normal; both flag anything over 50 mA.
Related battery answers
Common follow-up questions
What should a car battery read on a multimeter?
About 12.6 volts or more with the engine off and the battery rested means fully charged (Battery Tender, Interstate Batteries, Optima). 12.4 V is about 75% charged and 12.2 V about 50%; 11.9 V or less is considered discharged (NAPA, Battery Tender). AGM batteries read a little higher when full, about 12.8 to 13.0 V (Battery Tender).
Is 12.2 volts OK for a car battery?
It will often still start the car, but it's only about 50% charged (Battery Tender, NAPA). Battery Tender says to recharge before any further testing, and that sitting partly discharged raises the risk of sulfation, which shortens battery life.
What voltage is too low to start a car?
There's no single cutoff for starting, but during cranking a good battery should stay above 9.6 volts (NAPA, Advance Auto Parts). At rest, a battery at 12.0 V is only about 25% charged and at 11.9 V or below it's considered discharged (Battery Tender, NAPA); a cold morning makes a weak battery even less likely to start the car.
What should the voltage be with the engine running?
13.7 to 14.7 volts across the battery terminals (NAPA, Optima, Battery Tender). Battery Tender says below 13.5 V suggests the alternator isn't charging properly or the belt is loose, and above 15 V suggests the voltage regulator is failing and overcharging. Interstate Batteries' video uses a simpler bar: anything above 13 V.
How do I know if it's the battery or the alternator?
Test both. If the battery holds 12.6 V after a full charge and stays above 9.6 V while cranking, but the running voltage is under about 13.5 V, suspect the alternator or belt (Battery Tender). If running voltage is 13.7 to 14.7 V but the battery won't hold a charge overnight, suspect the battery or a parasitic drain. Optima recommends a professional load or bench test as the definitive check.
How do I test for a parasitic drain with a multimeter?
Lock the car and let it sit 20 to 45 minutes so its computers go to sleep, then disconnect the negative battery cable and connect the meter set to 10 A DC in series between the negative post and the cable end (Battery Tender). Normal is roughly 20 to 50 milliamps; over 50 mA is worth tracking down by pulling fuses one at a time until the reading drops. Don't open the doors or crank the engine while the meter is in series.
Why did my battery read 12.8 volts and still die?
Probably surface charge. Battery Tender says measuring soon after driving or charging gives a falsely high reading, and that a healthy battery should still read above about 12.4 to 12.5 V after sitting a day. If it reads fine at rest but drops below 9.6 V cranking, the battery is weak even though the resting voltage looks good.
Is a multimeter test as good as a load test?
No. A voltmeter shows state of charge, and the cranking test gives a rough load check, but Interstate Batteries says a 12.5 V reading doesn't mean you have a good battery, and Optima recommends professional load-testing or bench-testing to be sure.
Sources
- 1.Battery Tender: How to Test Your Car Battery at Home: 5-Step Multimeter Guide (2026)
- 2.Battery Tender: Car Battery Won't Hold Charge: Rest-Voltage Test Guide (2026)
- 3.Interstate Batteries: How to Test a Car Battery with a Multimeter (video)
- 4.NAPA Know How: How Many Volts Is a Car Battery? (Matthew C. Keegan, 2020, updated 2022)
- 5.Advance Auto Parts: How To Test A Car Battery's Voltage (updated Feb 23, 2022)
- 6.Optima Batteries: How Do You Tell if it's the Alternator or the Battery? (Jim McIlvaine, 2020)
General information only, not a diagnosis. Your owner’s manual comes first. How we write these